The cold and wet side
Dishwasher repair.
Standing water, cloudy glasses, or a cycle that quits early. Each has a known cause.
The cold and wet side
Standing water, cloudy glasses, or a cycle that quits early. Each has a known cause.
Dishwashers fail quietly. A drain pump that weakens, a spray arm that clogs, a circulation motor that loses pressure, a door seal that starts letting water find the floor. The symptoms show up as dishes that stop coming out clean long before anything refuses to run.
We service Bosch, KitchenAid, Whirlpool, Maytag, GE, Samsung, LG, Frigidaire, Electrolux, and Kenmore machines, from builder grade to panel integrated, and we leave the machine cleaning like the day it was installed.
Water standing in the sump after a cycle. The pump, the valve, or the hose loop, and we test all three.
Food on the upper rack after a full cycle means the wash motor or the filters are not moving water like they should.
No fill, slow fill, or overfill. Valves scale up and floats stick, both routine.
A latch that will not catch stops everything. A seal that weeps ruins floors slowly. Both worth fixing the week you notice.
Wet dishes at the end and film on glassware often trace to the heating circuit, not the detergent.
Cycles that stall or lights that blink in code. We read the code and test the answer before parts move.
A small amount in the sump is by design. A pool across the whole floor of the tub is not, and it means the drain path wants attention.
Could be either. Hard water film and etching look similar, so we check the heater, the rinse aid system, and the water before blaming the soap.
Yes. Integrated machines are half our dishwasher work, and custom panels come off and go back on without a mark.
One call and it is off your list. Open daily, 7am to 7pm.
Same day windows go to whoever calls first. The $89 diagnostic folds into your repair, so finding out costs nothing extra.